BMW Diagnostic Software for X-431 Series V47.40
元征软件     2014-04-22

        'Compared with V47.30:
        up''||''&''||''#100;ates as following:
        Added the special functions of Oil Change and Repair for the VTG (Transmission control system) under chassis E83, F01, E90, and E70.
        Added the special function of ICM sensor system adjustment for the ICMQL system under chassis F01 and F25.
         Added the special functions of HSR function check (deflection test), Rear axle wheel alignment, and Start-up HSR rotor position sensor for the HSR (Rear axle slipping angle control) system under chassis F01.
        Added the special function of Start-up of Active Steering for the ASA system under chassis F01.
        Added the following special functions for the DSC (Dynamic stability control) system under chassis F01, F25, F20, and F10: Brake bleeding procedure, DSC control unit adjustment, Mix-up checks brake lines
         Added the following special functions for the EHC (Electronic height control) system under chassis F01: Ride height sensor check, Activate compressor, Filling and discharging air from air bellows
        Added the following special functions for the ICMV (Integrated chassis control) system under chassis F01: Start-up fault evaluation, Adapt pressure sensors with fault evaluation, Self-diagnosis fault evaluation
        Added the following special functions for the DME (Digital motor electronic system) under chassis F01, F25, F20, F10, and F04: Air mass flow sensor, Electric fuel pump, Exhaust backpressure sensor before exhaust turbocharger, Mean quantity adaptation, Rail pressure regulating valve, Swirl flap actuator, Consumption calculation, Exhaust-gas recirculation, Idle speed, Starting torque, Bleeding fuel system, Regeneration particulate filter, Smooth running control, Valvetronic adaptation limit positions, Valvetronic running-in phase, Injector rate adjustment, Clear adaptations, Consumption calculation adjustment, Register battery change, Evaluate battery charge state, Idle speed adjustment, Learning valvetronic limit position, Ventilation Cooling system, Display On-board Diagnosis readiness codes, Register starter exchange
         Added the following special functions for the EGS (Electrical automatic transmission) system under chassis F01, F10, and F07: Display and reset adaptation values, Immobiliser reset function, Resetting adaptation function, Oil balancing, Data adjustment, mechatronics, Flushing function, Format fault memory, Clutch adaptation, Gearbox adaptation, Learn in of valve characteristic curve, Reset torque characteristic curve, Parking lock function check, Parking lock hook test, Integrated electrical pump
        Added the following special functions for the CAS (Car access system) under chassis F01 and F20: Reset starter lock, FEM KL15 activation/deactivation, CAS KL15 activation/deactivation, Disable/enable, Personalisation number, Block/enable
        Added the special function of EPS start-up for the EPS (Electronic power steering) system under chassis F25, F20, and F10.
        Added the special function of Initial operation for the EMF (Parking brake) system under chassis E89.
        Added the coding function for the SRS and EHC (Electronic height control) under chassis E39.
        Added the correction function for the CBS under chassis F.
        Added the special function of Register battery change for the DME (Digital motor electronic system) under chassis F25.
        Added the following special functions for the DME (Digital motor electronic system) under chassis F10: Register battery change, Valvetronic adaptation limit positions
        '

Copyright©2012:SHENZHEN LAUNCH SOFTWARE DEVELOPMENT CO., LTD. All rights reserved.
Hotline:400-066-6666